Kitchen wall tiles in Muzaffarpur: 300×450 glossy for behind the stove and sink
- Glossy 300×450 ceramic
- Laid on its side
- 2 ft band over the platform
- 4 ft strip behind the stove
A glaze does not soak up oil, so a damp cloth takes the splash off. Tile the 2 ft between the platform and the overhead cabinets, and carry the tile from the platform up to 7 ft behind the stove, where the oil and soot land. A wall tile goes on the wall and a floor tile on the floor, never the other way round.
Tile the band, then carry it up behind the stove
Most of a kitchen wall never gets splashed. Oil and water land in two places: along the platform, where you cut and wash, and above the burners. Tile those two and the rest can be paint.
The band: platform to cabinet
Usual practice puts the overhead cabinets 18 to 24 inches above the platform, so the band is about 2 ft. Run it the full length of the platform, light tile below and one highlighter row on top.
The stove strip: platform to 7 ft
Behind the stove the tile goes up past the cabinet line, to 7 ft or the top of the chimney, about 4 ft above the platform. Make it at least as wide as the stove; 3 ft is common. This is the wall that takes the oil and the soot.
Behind the sink
Same band as the rest of the platform. If the sink sits under a window, stop the tile at the window frame and cut around the tap pipes rather than leaving a patch of bare plaster.
Turn the tile on its side
A 300×450 tile standing up is 450 mm tall. A 600 mm band is then one tile plus a 150 mm cut strip along the whole run, and every cut piece is waste. Turn the tile on its side and two rows are 2 × 300 = 600 mm: no cutting along the band, and the top joint meets the cabinet. Behind the stove, four rows are 1,200 mm, which is 4 ft.
If your mason prefers the tile standing, the area and the boxes are the same. Only the cutting changes.
For a kitchen wall we pick glossy
1Glossy: wipes in one pass
Oil and masala sit on top of the glaze, and one pass with a damp cloth clears them. It also throws light back, which helps a small kitchen with one window. Orient Bell's kitchen guide recommends glossy for walls and backsplashes for the same reason.
2Matt: fewer streaks, right for the floor
Some sellers prefer matt on the wall because water spots and finger marks show less. That is a choice of looks. Matt is the right surface where you walk, because slipping matters more there than wiping, so the kitchen floor is matt.
3The safe rule
Sellers split on this, so we use one rule: glossy on the wall you wipe, matt on the floor you walk on. The full comparison is on the matt vs glossy page.
Pick the highlighter first, then the plain tile to go with it
Each 300×450 wall series is a plain light tile (LT), often a dark plain tile (DK), and a highlighter (HL), the one with the picture. For a kitchen, most of the band is LT, with one HL row at eye level. These are the ones that suit a kitchen best.


Satvariyo-08 HL-5
Printed squares among white ones: lively, and hides a splash better than plain white. Pair it with Satvariyo-08 LT.

Satvariyo-08 LT
White with fine grey veins. The brightest choice for a small kitchen, and it carries the HL row above.

393 LT
A cool pale-blue wave. Series 393 also has a DK and an HL-1, but HL-1 is a dolphin picture, so see 393 under bathroom wall tiles.
Adhesive and grout: the parts that go dark first
The tile itself wipes clean. The joint is where oil and soot collect, so choose it with the same care.
Fix with TileStix TX2
Birla White TileStix Intero Grip+ (TX2) is made for ceramic tiles up to 450×450 mm indoors, and our 300×450 is inside that. Mix it with water only, 4.8 to 5.2 L per 20 kg bag, and never add cement. Tile goes on plaster, not on putty.
Fill with TileLynk
Birla White TileLynk is an un-sanded joint filler for 1 to 6 mm joints, in a 1 kg pouch. The maker says it takes water and stains better than ordinary cement grout. Its brochure lists white only, and white shows soot behind a stove. Keep the joint to about 2 mm (usual on wall tile) and wipe it with the tile. No cement grout is soot-proof.
Wait before you cook
Birla White asks for 24 hours after fixing before grouting or walking on TX2. Grout the wall tiles the next day, and let the joints dry before the stove goes back on.
Boxes for your kitchen wall
The same 10 ft counter wall, three ways. The stove strip adds only 6 sq ft over the band alone, and it is the part that earns its money.
A usual 8×10 ft kitchen has the stove and platform on the 10 ft wall and a sink run on one 8 ft wall. That is 26 sq ft plus 16 sq ft for the 8 ft band: 42 sq ft, 6 boxes. Put in your own sizes below.
Your list
Prices are from our latest bill and change often. Please confirm today's rate on WhatsApp or call before buying.
TileLynkAsk usBags of adhesive and pouches of grout depend on the joint and the bed. Send this list and we will work them out.Ask today's ratePrices are filled in from today's rate (tile rates). Floors, bathrooms and the whole house: tiles calculator.
The tiles, adhesive and grout
We sell genuine Birla Pivot tiles and Birla White adhesive and grout with a GST bill. Tiles are priced per box.
1102 HL-2 highlighterTeapot and coffee · 6 tiles per box₹ 186per box
1102 LT light plainPairs with 1102 HL-2₹ 186per box
Satvariyo-08 HL-5 highlighterPrinted squares on white₹ 186per box
Satvariyo-08 LT light plainWhite with grey veins₹ 186per box
393 LT light plainPale blue wave₹ 186per box
1217 LT light plain1217 also has DK, HL-1, HL-2₹ 186per box
Short answers
Which tiles are best for kitchen walls?
Glazed ceramic wall tile in 300×450 glossy. The glaze does not soak up oil or masala, so a damp cloth cleans it, and it reflects light in a small kitchen. Use a wall tile on the wall only; the kitchen floor needs a matt floor tile (see kitchen floor tiles).
Glossy or matt tiles for a kitchen wall?
Glossy for the wall, matt for the floor. Orient Bell's kitchen guide recommends glossy for walls and backsplashes because it is easy to clean. Some sellers prefer matt for the wall because it shows fewer streaks; that is a looks choice, and on a wall you wipe every day we would take the surface that wipes fastest. More in matt vs glossy.
How high should kitchen wall tiles go?
Usual practice: a band about 2 ft high from the platform up to the underside of the overhead cabinets, and from the platform up to 7 ft (about 4 ft) behind the stove, where oil and soot land. This is a custom, not a maker's rule; measure your own platform and cabinet height.
How many boxes of 300×450 tiles for an 8×10 ft kitchen?
With the stove on the 10 ft wall (2 ft band, 3 ft stove strip taken to 7 ft) it is 26 sq ft, which is 4 boxes with 10% for cuts. Add an 8 ft side wall with a 2 ft band (16 sq ft) and the total is 42 sq ft, which is 6 boxes. A box holds 6 tiles, 8.72 sq ft. Use the calculator on this page for your own wall.
Which grout will not turn black behind the stove?
No cement grout is soot-proof. Birla White says TileLynk resists water and stains better than ordinary cement grout, and its brochure lists one colour, white, so white will show soot. Keep the joint narrow (the maker allows 1 to 6 mm; 2 mm is common on walls) and wipe the joint with the tile. See TileLynk.
Can I put wall tile on the kitchen floor?
No. A wall tile is made lighter for the wall and is not meant to be walked on. Match the series with its 300×300 floor tile where one exists, or choose a matt floor tile. See kitchen floor tiles.
Do I put putty on the wall before tiles?
No. Tile goes on plaster. Putty is for the painted part of the wall above and beside the tile, never under it.
Paint Engineer at our Reva Road store, Muzaffarpur, who also looks after our tiles. Every figure on this page was checked against the maker's own sheet on 12 Nov 2026. Where makers or sellers disagree, the page says so and gives the safer choice.
Where the numbers come from
- Orient Bell, Kitchen tiles: glossy recommended for kitchen walls and backsplashes; highlighter tiles for the backsplash; sizes from 300×300 to 600×1200. No stove height or grout advice.
- Kajaria, Kitchen tiles: finishes and large formats, Gresbond adhesive. No stove height, box counts or grout advice.
- Fired Earth, Kitchen wall tiles FAQs: walls behind the hob and sink need high water resistance; grout may discolour. No height or quantities.
- Birla Pivot tiles catalogue (pp. 61–64) and birlapivot.com: 300×450 wall tile, 6 tiles and 8.72 sq ft per box; 1102 HL-2 is a glossy (GL) tile.
- Birla White, TileLynk brochure: un-sanded joint filler for 1–6 mm joints, 1 kg pouch, white, higher water and stain resistance than ordinary cement grout.
- Birla White, TileStix Intero Grip+ (TX2) brochure: ceramic and semi-vitrified tiles up to 450×450 mm, indoors; 4.8–5.2 L water per 20 kg; walk or grout after 24 h.
- Platform height (about 3 ft), the 18–24 in gap to the overhead cabinets and the 2 mm joint are usual practice, not a maker's figure. The 10% allowance for cuts is ours.
Send us your kitchen wall sizes
We will tell you the boxes, the adhesive and the grout, with today's price, on WhatsApp.