हिंदी Call90310 74624
Home›Problems and fixes
Problems and fixes

Ghar ki problem? Start from what you can see

The short answer
  1. Danger first
  2. Stop the water
  3. Let it dry
  4. Fix cracks
  5. Putty and paint

Find what you see on the wall, roof, floor or switchboard below, and open that page. The same patch can have different causes, so each page names the likely cause first and the fix second. Painting over a wet wall is the most common waste of money we see.

79
Problem pagesDamp, cracks, paint, tiles, water, electricity.
4
Checks at the wallTen minutes, no tools, tell you the route.
1
Order of repairWater before cracks, cracks before paint.
Where trouble enters a house
Where water and trouble enter a house Cross-section of a two-storey house with six numbered places: damp rising from the ground into the plinth, rain and a cracked parapet on the roof, a bathroom and pipe leaking into the room below, rain on the outer wall, damp air in a wardrobe, and a switchboard on a damp wall. WATER TABLE BATHROOM 4 2 3 5 1 6
  1. 1From the ground, through the plinth
  2. 2Roof and parapet
  3. 3Bathroom or pipe, into the room below
  4. 4Rain on the outer wall
  5. 5Damp air shut in a cupboard or room
  6. 6Electricity on a damp wall: first of all
Blue is water. Not to scale. Tap a line in the key to jump to that route.
Before you open any page

Ten minutes at the wall: four checks

The patch lies about its cause. A damp spot low on a wall can come from the ground, a pipe or rain. These four checks sort most cases before you spend anything.

1How high is it?

Low on the wall, near the floor, usually means the ground. High on the wall, or on the ceiling, means the roof, a pipe or the outer wall.

2When does it get worse?

A patch that darkens after rain comes from outside. One that stays the same in dry weather comes from a pipe, a bathroom or the ground.

3What is on the other side?

A bathroom, a kitchen sink or an overhead tank behind the wall points to a leak from that side.

4Touch it

Cold and wet: water is still arriving. Dry but powdery with white salt: water came and left, and the salt is what stays behind.

Bihar makes this harder. North Bihar has a high water table, so ground damp is common even in a house with no other fault, and a flood can leave walls wet for weeks. After the water goes down, wait before you judge the damage. Leak: where from? (guide)

Five ways water gets in

Which route is yours? Each one has its own fix

The product depends on the route. The numbers match the drawing at the top.

Water comes fromWhat you seeOur fix, from the shelf
1The ground, up through the plinthDamp low on the wall, a tide line, white saltPages: damp wall, white salt, after a floodBirla White Seep Blocker 2K, Seep Guard; then waterproof puttyBuilding new: the plinth layer, DPC
2Roof or parapetStains or drips on the ceiling, worse after rainPages: roof dripping, cracks in the slabUltraTech Weather Pro Hi-Flex (coating) and WP+200 in the repair mortarParapet · Terrace
3A bathroom, kitchen or pipeWet wall or ceiling in the room below or next doorPages: bathroom water below, hidden leakSeal & Dry SBR in the base coat, Hi-Flex under the tilesBathroom waterproofing
4Rain on the outer wallThe wall is wet and dark in rain, damp inside afterPages: black fungus, paint peeling outsideWP+200 in the plaster, Birla Opus exterior paintOuter walls
5Damp air shut inA musty smell, fungus in a cupboard, nothing wet to touchPages: musty smell, damp wardrobeAir first: a gap behind the cupboard, open windows on dry days, an exhaust fan. Check the wall behind it is not route 1 to 4.Seelan, seepage, leakage: the difference
Electricity comes before everything else. If a damp wall has a switchboard on it, a socket that heats, a wire that smells or a tap that gives a shock, switch that line off at the MCB and read the electrical pages before you touch the wall. Damp walls and electricity · Current in the tap or body
The order we work in

Fix in this order, whatever the problem is

Painting first only hides the fault for one season. The same patch returns, usually bigger.

  1. 1. Danger firstAnything that sparks, heats or shocks. Switch it off and deal with it before the wall.
  2. 2. Stop the waterFind the way in and close it: the roof joint, the pipe, the crack. Not the stain.
  3. 3. Let the wall dryTest by touch and colour. Usually a few weeks after the leak is fixed.
  4. 4. Repair cracksFill cracks and weak plaster. Hairline cracks come back through paint if left.
  5. 5. Putty and paintOnly now. Putty on a damp wall is why paint lifts a few months later.

Paint over a wet wall

You see: bubbles, then peeling

The paint cannot grip while water is still coming through. It lifts, and the wall is worse than before.

Mending the patch, not the entry

You see: the stain moves sideways

Water finds the next weak spot. Close the way in, and the wall can dry.

Sealing the crack, ignoring the source

You see: damp beside the sealed line

A sealed face over a wall that is still taking water only pushes the damp somewhere else.

Find your problem

What do you see? Pick it from the list

Type a word (seelan, namak, crack, MCB) or pick a group. Every page starts with the likely cause.

Damp, seelan and leaks 21 pages

Nothing matches that word. Send us a photo on WhatsApp and we will tell you the likely cause.
On our shelf for these jobs

The products, by the route they stop

Every product can be ordered. If it is not on the shelf, ask on WhatsApp for the time it takes.

Pack sizes are from our shelf. Today's price of every pack: putty and white cement rates · paint rates · all waterproofing

Questions people ask us

Short answers

Ghar me seelan kaise roke? (how to stop damp in the house)

First find where the water comes from: the ground, the roof or parapet, a bathroom or pipe, or rain on the outer wall. Use the fix for that route, let the wall dry, and only then putty and paint. The table above names the product for each route, and the damp-wall page has the steps.

Chhat se pani tapak raha hai to kya kare?

Water that drips inside has often travelled some way along the slab, so the wet spot is not always under the leak. Look at the parapet joint, cracks and pipe edges on the roof, close the entry with the roof coating and the repair mortar, and do the proper repair after the rain. Steps are on the roof-leak page.

Deewar me seelan ka ilaj kya hai?

It depends on the route. Damp low on the wall, with a tide line and salt, comes up from the ground and is treated at the plinth side. Damp high on the wall or ceiling comes from the roof, a pipe or rain on the outer wall. Paint does not treat any of them.

Can I just paint over a damp wall?

No. The paint will bubble and peel and the patch comes back, usually bigger. Stop the water, let the wall dry fully (test by touch and colour; usually a few weeks after the leak is fixed), repair cracks, then putty and paint.

Is the problem in the wall or in the pipe?

A patch that keeps growing in dry weather, next to a bathroom, kitchen or tank, points to a pipe or floor leak. A patch that appears or darkens after rain points to the roof or outer wall. The tank-level test on the hidden-leak page settles it, or send us a photo.

Which problem should I fix first if I have several?

Anything electrical that sparks, heats or gives a shock comes first, before everything else. Then water, then cracks, then putty and paint.

My house was flooded. How soon should I repair the walls?

Not at once. Walls stay wet for weeks, and salt can show a month or two later even on a wall that looks fine in the first week. Let them dry, then follow the after-flood pages for what to strip and what to rebuild with.

Arun Tiwari
Site and plumbing advice, Tashya Ventures

Arun looks after site questions and plumbing at our Reva Road store, Muzaffarpur. Send photos on WhatsApp before dhalai or before plaster, and he will look at them with you.

Where this page comes from

  1. Our store's own working order and the products we stock for each route (water first, then drying, cracks, then putty and paint).
  2. Birla White, How to fix damp walls (16 Aug 2025): rising damp, penetrating damp, condensation and leaking pipes as separate causes; fix leaks before any coating; repainting alone is only cosmetic.
  3. Each problem page names its own sources.

Not sure which one it is? Send a photo

Send a photo of the wall, roof or switchboard on WhatsApp, with where in the house it is. We will look at it with you and tell you the likely cause.

TASHYABUILDING SOLUTIONS · MUZAFFARPUR
WhatsApp 90310 74624tashyaventures.com